TR500 Install Guide

🚗 Linxio GPS 4-Pin Tracker – Basic Installation Guide

⚙️ 1. Identify the 4 Wires

Most Linxio 4-pin harnesses use the following standard colors:

🔌 2. Mount the GPS Tracker

• Choose a hidden but signal-friendly location inside the vehicle.
• Common spots: under dashboard, behind glove box, or under rear parcel shelf.
• Avoid placing it directly under metal surfaces.
• The GPS antenna side (flat top) should face upward toward the sky.

⚡ 3. Connect Power and Ground

• Connect the red wire to a constant 12V/24V power line — directly from the fuse box or battery.
• Use an in-line fuse (1A–3A) to protect the circuit.
• Connect the black wire securely to a clean ground point on the chassis.

🔑 4. Connect the Ignition (ACC) Wire

• Find a wire that has 12V/24V only when ignition is ON, Use a Multimeter for this.
• Connect the orange wire there.
• This allows Linxio to detect when the engine is running or off.

🧩 5. (Optional) Connect the Relay / Cut-Off Function

If your tracker supports immobilization (fuel cut, starter disable, etc.):

• Use the Yellow Wire from the tracker to control a relay.
• Wire the relay in series with the fuel pump or starter circuit.
• When activated via the Linxio platform, the relay opens the circuit — disabling the vehicle.

( Please skip this step if you’re doing a standard tracking-only install.)

📶 6. Test the Unit

1. Turn ignition ON.
2. Check tracker LEDs — you should see:

• Power LED (solid)
• GPS LED (blinking, then solid once locked)
• GSM LED (blinking indicates network activity).

3. Verify the tracker reports live location in your Linxio platform/app.

Updated on: 12/11/2025