VX60 and Y Splitter (Concealment Kit)

The VX60 is a Plug n Play device that simply plugs into the Vehicle's OBD2 port.

If you are having trouble locating where the port is on your vehicle, please refer to your Vehicle Handbook, or simply Google "Vehicle Make/Model, Year + OBD2 Port".

Y Splitter cable installation (Concealment Kit)

The VX60 is a Plug n Play device that simply plugs into the Vehicle's OBD2 port.
If you are having trouble locating where the port is on your vehicle, please refer to your Vehicle Handbook, or simply Google "Vehicle Make/Model, Year + OBD2 Port".

There are 3 lines coming from the center of the Y splitter cable. Holding the Splitter cable up by the "Arms", there are two arms that come from the middle, followed by a single "Tail" below.

To install a Y Splitter cable, first remove the vehicles OBD2 attachment from the plastic housing (note you may need to remove screws with a screwdriver to detach the port) - then, connect the VX60 to one of the "Arms", after connect the Tail into the now-free OBD2 port.

Once these are connected, check to ensure lights are flashing on the VX60, then place the "free" arm not connected to anything back where the OBD2 port once was. This now acts a bypass, and "conceals" the VX60 tracker and deters people from removing the device. It also acts a bypass for technicians to access the ECU.

Video demonstration

If you have tried all the above steps and the device still does not have solid lights, please call our support team on 02 7908 5453 or Lodge a support ticket on your dashboard under Support.

Updated on: 05/09/2025